When you want astonishing results for less cost than many other brands - PrimaCreator VALUE resin should be your first choice!
Warning: Last items in stock!
The resins from the PrimaCreator VALUE line are high-quality resins made from the best possible materials. Your prints can be cured in sunlight or a UV curing chamber. When the curing is finished, the result is a rock-hard print with minimal shrinkage.
The finished print is a solid colour part with a beautiful semi matte surface, excellent details and smooth layer transitions.
If you go for the transparent resins you will have crystal-clear transparency which is truly stunning.
VALUE resin has many benefits over other brands of comparable resins.
The most noticeable is that it does not produce nasty odours.
VALUE resin is developed to perform well on low powered DLP machines such as the Wanhao Duplicator 7, SparkMaker Anycubic Photon, Zortrax Inkspire and other printers that use UV light for curing.
Optimized for UV Lightsource 395 – 405 nm.
Fast curing time, 4 – 8 seconds per layer for quicker prints.
After printing, you can clean you print in IPA (Isopropyl Alcohol) to rinse leftover resin.
When it´s time for curing you can use sunlight or a uv curing chamber.
Depending on the print the curing times can vary:
In a UV light curing chamber, it will take about 2-5 minutes.
In sunlight, 10-20 minutes.
In daylight on a cloudy day it can take up to 60 minutes.
|UV Lightsource Wavelength:||395 - 405 nm (optimal)|
|Viscosity:||100-150 (25℃ m.pa.s)|
|Density:||1.05 - 1.13g/cm³|
|Hardness||85-88 Shore D|
|Tensile strength:||42.0 Mpa|
|Flexural Strength:||60 Mpa|
|Elongation at break:||10%|
|Storage temperature||5 - 40℃|