Modifi3d Finishing Tool


New product

The versatile Modifi3D finishing tool performs simply minor modifications and repairs to your 3D printed objects. Improving the surface finish is also done with this tool. So you can perfect 3D printing to perfection.

All the points are provided with a special coating which prevents the plastic from sticking .

€ 34,50 tax incl.

Add to wishlist

In stock

More info

MODIFI3D, Features

The MODIFI3D is characterized by;


  • 4 interchangeable tips; Needle, knife, scoop and point tips.
  • Rapid heat up in less than 15 seconds.

  • Sleep mode if not used for 25 seconds.

  • Simple and easy to use.

  • Lightweight and compact.

  • Touch switch and indicator light.

  • USB powered (USB 2.0 or USB 3.0).

  • Basic stand included.


MODIFI3D, step by step

  1. Remove the protective cap (if used) and place MODIFI3D on the included stand.
  2. Plug in the USB (USB 2.0 or 3.0 recommended).
  3. Touch the metal switch to start heating. A red light indicates that MODIFI3D is switched on.
  4. In less than 15 seconds MODIFI3D will reach around 300ºC (572ºF) and is ready for use. To increase the temperature or reach the maximum of 420-450ºC (788-842ºF) continue to touch the metal switch until the required temperature is reached.
  5. If MODIFI3D is not used for 25 seconds it will go into sleep mode (light will go out and the tip will start to cool). To wake MODIFI3D just gently touch the switch and the heating process will continue.
  6. Always unplug the USB if MODIFI3D is not being used.


MODIFI3D, quick change of tips

  1. To change tips unplug the USB and allow the MODIFI3D and tip to cool fully.
  2. Unscrew the locking nut and pull out the tip

    Push the replacement tip in fully and tighten the locking nut

    Plug in the USB... Easy!


The MODIFI3D tips

Knife tip


Cutting and removing sections including the removal of supports, brims, and rafts.


Needle tip


Great for clearing small holes and features or for detailed layer refinements in hard to reach places.


Point tip


General purpose tip for larger internal features and holes. Can even be used for making holes after printing!




Scoop tip


Perfect to remove stringing and imperfections from inside holes or recesses. Can also be used to blend surfaces where blobs have appeared.


30 other products in the same category:

WebwinkelKeur Webwinkel Keurmerk

vink   European Trust Mark

vink   Fast replies on e-mail 24/7

vink   Free shipping 3D Printers (Benelux)

vink   Expert advice

vink   Fast deliveries

vink   Voucher after review

Comodo EV-SSL Logo

Viewed products

De waardering van bij Webwinkel Keurmerk Klantbeoordelingen is 9.3/10 gebaseerd op 301 reviews.