PrintaStick

001003

New product

PrintaStick works with all materials and secures a strong bond to the buildplate until the 3D print is finished. The sponge applicator makes the usage of PrintaStick easy, precise and effortless. During application and printing PrintaStick does not release or produce any unpleasant smell and after the print is finished there is no visible trace of PrintaStick on the 3D print.

€ 9,90 tax incl.

Add to wishlist

More info

Advantages

  • Strong formula works for many materials
  • precise to apply
  • high temperature stable
  • no unpleasant smell

PrintaStick or PrintaFix

 PrintaFixPrintaStick
Recommended for unheated printbedsYes*
Recommended for heated printbedsYesYes
Precise to apply~Yes
Works with general materials: 
PLA, PET-G, M-ABS,...
YesYes
Works with special materials:
WOOD, PURE, PET-G CF20, FLEX HARD, METAL, HIPS,...
YesYes
Works with professional materials:
PA6, PA12, PC-ABS,...
~Yes

Manual

1. Preparation: Shake PrintaStick for a few seconds to mix the solution. Only apply on a cold residue free printbed. If necessary you can use PrintaClean to remove residue from the printbed.

2. Apply PrintaStick by pressing the sponge applicator on the printbed to release some liquid. Then spread the liquid by moving the sponge in a circular pattern over the printbed. If the sponge hardens – rinse with clean water to soften.

PrintaStick application

3. Finish and Clean Up: Start the printing process with recommended temperature settings. The liquid will dry up during the heat up process of the printbed and leave a fine film that enables the connection to the 3D print. After your print has finished, wash off with water

HAZARD AND PRECAUTIONARY STATEMENTS

EN: Contains preservative(s): Isothiazoli-none mixture 3:1 (CIT/MIT). Contains 1,2-Benzisothiazol-3(2H)-one. May produce an allergic reaction. Keep out of reach of children. If medical advice is needed, have product container or label at hand. Do not get in eyes, on skin, or on clothing.

Reviews

Write a review

PrintaStick

PrintaStick

PrintaStick works with all materials and secures a strong bond to the buildplate until the 3D print is finished. The sponge applicator makes the usage of PrintaStick easy, precise and effortless. During application and printing PrintaStick does not release or produce any unpleasant smell and after the print is finished there is no visible trace of PrintaStick on the 3D print.

Write a review

30 other products in the same category:

benefits
WebwinkelKeur Webwinkel Keurmerk


vink   European Trust Mark

vink   Fast replies on e-mail 24/7

vink   Free shipping 3D Printers (Benelux)

vink   Expert advice

vink   Fast deliveries

vink   Voucher after review


Comodo EV-SSL Logo

Specials

Viewed products

De waardering van www.3dware.nl bij Webwinkel Keurmerk Klantbeoordelingen is 9.3/10 gebaseerd op 301 reviews.