PrintaClean View larger

PrintaClean

001901

New product

500ml | Remove residue from the build plate with ease.

€ 7,50 tax incl.

Add to wishlist

In stock

More info

Find it hard to remove leftover residue from your build plate? PrintaClean is a powerful solvent to effectively remove nasty sticky residue from the build plate. This gives you a clean slate for your next creation.

Application: Just spray a good amount of solution on the build plate. Let it sit for 20-30 seconds to loosen the residue. Wipe off with a paper towel.

HAZARD AND PRECAUTIONARY STATEMENTS

Signalword: Danger
Precautionary statements:
If medical advice is needed, have product container or label at hand. Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. If eye irritation persists: Get medical advice/attention. Dispose of contents/container safely.
Hazard statements:
Highly flammable liquid and vapour. Causes serious eye irritation. May cause drowsiness or dizziness.

Reviews

Write a review

PrintaClean

PrintaClean

500ml | Remove residue from the build plate with ease.

Write a review

30 other products in the same category:

benefits
WebwinkelKeur Webwinkel Keurmerk


vink   European Trust Mark

vink   Fast replies on e-mail 24/7

vink   Free shipping 3D Printers (Benelux)

vink   Expert advice

vink   Fast deliveries

vink   Voucher after review


Comodo EV-SSL Logo

Specials

Viewed products

De waardering van www.3dware.nl bij Webwinkel Keurmerk Klantbeoordelingen is 9.3/51 gebaseerd op 6 reviews.