Polymaker Polisher Black

70524

New product

The Polymaker Polysher is a specially designed machine to optimize your PolySmooth 3D prints.

This easy to use machine uses an alcohol mist to post process your prints. After this process, your 3D print has a smooth, clean top layer.

€ 349,94 tax incl.

Add to wishlist

More info

The Polymaker Polysher is a specially designed machine to optimize your PolySmooth 3D prints. This easy to use machine uses an alcohol mist to post process your prints. After this process, your 3D print has a smooth, clean top layer.

Intuitive and easy to use

Just as its filaments, Polymaker created the Polysher to be easy to use. Simply twist the dial to set the time and the Polysher will do the rest. Thanks to its design, with smart electronics and an air tight seal, you do not have to worry about anything. The Polysher combines quality with an affordable running cost.

Post process your prints as you want
The Polysher vapes the alcohol mist in the machine, which will create an amazing finish on your prints. After the prints are dried and cleaned, you can paint over them and create your own ideas.

Be aware!
Only Polymaker PolySmooth filament can be used for optimizing your prints in the Polysher. Other materials will give minimal to no results.

You also have to purchase PolySmooth separately, just as the alcohol. These items are not delivered with the Polymaker Polysher.

Technology:Nebulized Aerosol Polishing
Compatible material:PolySmooth
Polishing liquid:Isopropanol or ethanol, 70% or above [90% or higher recommended]
Polishing time:10 - 30 min. typical
Dimensions:230 x 270 x 370mm
Maximum Polishable Size:150 mm (diameter) x 180 mm (height) cylinder
Operating temperature:15 - 32°C
Storage temperature:0 - 38°C
Power Requirements:100 – 240 V, 2A max, 50/60 Hz

Reviews

No customer comments for the moment.

Write a review

Polymaker Polisher Black

Polymaker Polisher Black

The Polymaker Polysher is a specially designed machine to optimize your PolySmooth 3D prints.

This easy to use machine uses an alcohol mist to post process your prints. After this process, your 3D print has a smooth, clean top layer.

Write a review

25 other products in the same category:

benefits
WebwinkelKeur Webwinkel Keurmerk


vink   European Trust Mark

vink   Fast replies on e-mail 24/7

vink   Free shipping 3D Printers (Benelux)

vink   Expert advice

vink   Fast deliveries

vink   Voucher after review


Comodo EV-SSL Logo

Specials

Viewed products

De waardering van www.3dware.nl bij Webwinkel Keurmerk Klantbeoordelingen is 9.3/51 gebaseerd op 6 reviews.